5. When the temperature is high, the marking line will be slightly deformed, and the average point is taken; The marking line is drawn by hand, and the ink dots on the edge of the line are averaged;
6. There are 4 stations in the oven, 4 small dumbbell test pieces are placed;
7. Four 1.3 million low pixel fixed cameras were tested for continuous shooting. 12. Lighting lamps shall be set outside the glass, and the upper and lower rows shall be set in parallel;
8. During continuous shooting, the time for an IPC to analyze 4 pictures is 120ms, and the real-time length is refreshed 8 times per second;
9. The temperature of the oven is 200 ℃, and the initial design excludes the scheme of built-in shooting parts;
10. The tension of the electric tension machine is determined according to the thickness of the small dumbbell test piece, with the thickness of * 81.6, taking 0.5g as the whole;
11. The temperature of the oven shell is not hot, not higher than 50 ℃, except for the edge of the door; The temperature uniformity at 9 points in the test area inside the oven shall not exceed ± 2 ℃; 12. The oven shall be heated from room temperature to 200 ℃ for no more than 20 minutes;
13. When the side sliding door is opened for 30 seconds, the time to recover to 200 ℃ after closing shall not exceed 5 minutes;
14. The overall width of the oven after opening the door shall not exceed 1.5m;
15. The stability and safety of the fixture during operation shall be high, including four steps: putting in, pulling up, lowering and putting out, without affecting the access of the side sliding door and the up and down movement of the station; The heat dissipation measures shall be reasonable, and the electronic components shall not operate at high temperature;
16. The precision of tension machine in stable state is ± 0.25g;
17. Sound and light prompt is required; The closing of the electric door requires sensor sensing; The automatic clamp shall be servo motor driven.
